Harley davidson American Classic Straights on a 1988-2001 VLX 600 Shadow...
download Remove right side Foot peg assembly or Floorboard. (Whichever is applicable to your model.) 2. Remove bolts that are holding pipes at rear mounting bracket. 3. Loosen clamps at mufflers. 4....
View ArticleKawasaki VN1600 Highway Bar INSTALLATION AND OWNER'S MANUAL
download PREPARATION 1. Insure that the motorcycle is on flat level ground. 2. It is recommended that the motorcycle sit for at least one hour prior to installation to allow the engine to cool. During...
View ArticleHARLEY DAVIDSON XR1200 LUGGAGE RACK KIT REMOVAL AND INSTALLATION MANUAL
download Kit 53976-08 (XR1200 Passenger Upright Kit) is available for separate purchase. Contact your Harley-Davidson dealer for more information. Kit Contents See Figure 2 and Table 1. REMOVAL 1....
View ArticleHONDA GL1100 AM/FM RADIO INSTALLATION MANUAL/ WIRING DIAGRAM
download INSTALLATION ■ Outline Procedures This section gives general information needed for mounting the individual radio components on and in the fairing. A) Fairing 1) Install radio on fairing...
View Article1990 Harley Davidson ULTIMA 6 SPEED BUILDERS KIT INSTALLATION INSTRUCTIONS
download For 2000 & later models removal of approximately 1/4 of an inch off of the shifter arm bushing is likely required. Doing so will allow installation of the retaining clip & washer onto...
View ArticleHARLEY DAVIDSON HEEL REST KIT INSTALLATION MANUAL
download Models Kit 50227-01 is designed for forward controls and fits: •1989 and later FX Softail Models with Original Equipment (OE) Forward Controls, •1993 through 2002 FXDWG, •Dyna models equipped...
View ArticleHARLEY DAVIDSON BLADE FRONT WHEEL KITS INSTALLATION MANUAL
download INSTALLATION 1. Remove existing front wheel assembly. Save axle, axle nut, brake disc, and wheel spacers for kit installation. Refer to FRONT WHEEL in service manual. For FLSTC and FLSTN...
View Article2006-up Harley-Davidson Single Bore Induction System Installation Instructions
download Remove the stock fuel induction system, including the manifold and disconnecting all wire connections. It is up to the technician as to whether the gas tank should be removed or just raised up...
View ArticleHarley Davidson Road Rod Saddle Bag System Kit INSTALLATION Instructions
download Use locktite on all fasteners!! 2. Put bike on lift and place jack under frame. Raise bike to lift rear wheel. 3. If swing arm pivot shaft is drilled and tapped on each end, they need to be...
View ArticleHARLEY DAVIDSON FRONT THUNDERSTAR WHEELS INSTALLATION
download Remove existing front wheel assembly. Save axle, axle nut, brake disc, and wheel spacers for kit installation. Refer to FRONT WHEEL in service manual. For FLSTC and FLSTN Models: Discard...
View Article
More Pages to Explore .....